Advertisement
Test and Measurement, Function Generators

Eastern OptX Introduces Dynamic Radar Target Scenario Generator

June 10, 2014 8:02 pm | by WDD Staff | Product Releases | Comments

Eastern OptX introduced its Series 10000 Radar Scenario Generator. Features include: Scenario generation that includes speed of target, opening, or closing Doppler frequency addition; dynamic Doppler radar addition imposed directly...

LISTED UNDER: Test and Measurement, Function Generators | Test and Measurement, Noise Generators | Test and Measurement, Signal Generators

Stand-Alone Generator for Slow Damped Oscillatory Wave Testing from Teseq

January 10, 2014 1:16 pm | by WDD Staff | Product Releases | Comments

Teseq has introduced an easy-to-use, stand-alone generator for slow damped oscillatory wave testing in single phase equipment up to 270 V and 16 A. The new NSG 3040-SOW is in compliance with current testing standards IEC/EN 61000-4-18 and ANSI C37.90.1...

LISTED UNDER: Test and Measurement, Function Generators | Test and Measurement, Noise Generators | Test and Measurement, Oscilloscopes

Long Waveform Memory

March 20, 2013 11:16 am | by WDD Staff | Wireless Design & Development | Product Releases | Comments

Tektronix, Inc. has unveiled its next generation of arbitrary waveform generators that offer up to 50 GS/s sample rate performance. With a combination of high sample rate, long waveform memory, and deep dynamic range, the new AWG70000 Series...

LISTED UNDER: Test and Measurement, Function Generators | Test and Measurement, Noise Generators | Test and Measurement, Signal Generators
Advertisement

Sweep Function Generators Can Produce Sine Waveforms from 0.1 Hz to 7 MHz

January 18, 2013 12:13 pm | Product Releases | Comments

B&K Precision announced two new DDS (direct digital synthesis) sweep function generators, models 4007B and 4013B, which improve upon the former models 4007DDS and 4013DDS with an enhanced user interface as well as lower prices. Models 4007B and 4013B can generate sine and square waveforms from 0.1 Hz to 7 MHz and 0.1 Hz to 12 MHz, respectively.

LISTED UNDER: Test and Measurement, Function Generators

Sensor Simulator Accepts Test Signals from a Voltage Function Generator

May 26, 2009 6:59 am | Product Releases | Comments

PCB Piezotronics introduces Model 401B04 ICP® sensor simulator, which installs in place of an ICP® sensor and accepts test signals from a voltage function generator. This model allows test engineers to make sure the entire measuring chain consisting of cable, ICP® or IEPE signal conditioning, and data acquisition system is set up properly and ready to take measurements; which is especially important when the cost of running a test is very expensive.

LISTED UNDER: Services, Calibration / Test | Test and Measurement, Function Generators

Keyboards Featured on Dual Output Function Generators

September 8, 2008 6:45 am | Product Releases | Comments

Protek Test and Measuremet offers its Model B8040FD DDS function generator. This high stability direct digital synthesis dual-output function generator has less than -54 dBc (Sine wave) harmonic distortion and a keyboard for rapid entry of waveform parameters. It delivers 40-ppm long-term and 1-ppm short-term stability; it generates waveforms including Sine, Square, Pulse, Triangle, exponential up and exponential down, Ramp, Sine (x) x and ...

LISTED UNDER: Boards & Modules | Test and Measurement, Function Generators

Arbitrary/Function Generator

January 21, 2004 10:48 am | Product Releases | Comments

The Dual-Channel Arbitrary/Function Generator R&S AM300 has been added to the Rohde & Schwarz Smart Instruments family. As an I/Q generator, it can be used to generate complex digitally modulated signals as required for mobile radio. As a function generator, it can be used to output all conceivable standard waveforms on two independent channels....

LISTED UNDER: Test and Measurement, Function Generators

Function Generator

July 8, 2003 11:09 am | Product Releases | Comments

Novatech announces the Model 2904A, a precision DDS function generator in a tabletop instrument case. The 2904A outputs Sine, Cosine and TTL signals simultaneously. The Sine and Cosine output amplitudes are programmable with 12-bits of resolution for up to 24 dBm (10 Vpp into 50 Ω) output power....

LISTED UNDER: Test and Measurement, Function Generators

Synthesized Function Generator

April 6, 2001 5:21 am | Product Releases | Comments

TEGAM, Inc. has introduced the Model 3102 Synthesized Function/ARB Generator, which enables engineers and service technicians to define and output a wide range of electrical waveforms for circuit design, verification, and troubleshooting applications. The Model 3102's ability to produce sine, damped sine, square, and triangle waves, voltage ramps, noise, and arbitrary waveforms of virtually any shape makes it one of the most versatile wave ...

LISTED UNDER: Test and Measurement, Function Generators
Advertisement
X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading