Advertisement

HSDPA Test Equipment

June 1, 2005 7:02 am | Product Releases | Comments

Rohde & Schwarz announces that a range of measurement solutions are available for testing radio equipment and designed for use with High-Speed Downlink Packet (HSDPA), an expansion of WCDMA. Testing can be performed using the CRTU-W protocol tester, as well as the CMU200 and CMU300 Universal Radio Communication Testers....

LISTED UNDER: Services, Calibration / Test

Creating Wi-Fi Test Metrics

May 3, 2005 10:48 am | Product Releases | Comments

The constant mobility of the WLAN user coupled with the inherent instability of the unwired medium - air - make the 802.11 protocol an order of magnitude more complex than equivalent wired protocols. By Graham Celine Glossary of acronyms AES — Advanced Encryption Standard AP — Access Point BSS — Basic Service Sets CCMP — Counter-Mode/CBC-Mac Protocol (IEEE 802....

LISTED UNDER: Services, Calibration / Test

Test Assemblies

May 2, 2005 6:09 am | Product Releases | Comments

W. L. Gore announces the GORE™ PHASEFLEX® 110 GHz test assemblies. These test assemblies, with performance through 110 GHz, offer torque and crush resistance, as well as stability with flexure and temperature, all while remaining flexible. The devices provide good phase and amplitude stability with flexure over a wide temperature range....

LISTED UNDER: Services, Calibration / Test
Advertisement

Network Test System

April 4, 2005 8:47 am | Product Releases | Comments

Aspects launches a system for deep level testing of 3G phone, USIM, and network interoperability. The TTS 3G test system lets manufacturers and operators run a complete series of pre-conformance tests, validate any phone/USIM/network combination, and verify compliance with latest standards. Users are guided through every stage of testing, from confirming a single proactive command to verifying all of a phone's capabilities....

LISTED UNDER: Services, Calibration / Test

Thermal Testing Standard

February 25, 2005 9:12 am | Product Releases | Comments

Flomerics introduces Version 5 of its web-based Flopack software providing the ability to create Delphi compact models that predict the performance of electronic components under soon-to-be-published thermal testing standards from JEDEC committee JC-15.1. Flopack produces behavioral compact models that can predict the temperature of electronic component packages at critical points such as the junction, case, and board....

LISTED UNDER: Services, Calibration / Test

Vector Signal Test Equipment

February 25, 2005 9:12 am | Product Releases | Comments

The R&S FSMU-W from Rohde & Schwarz combines the vector signal generator R&S SMU200A with the vector signal analyzer R&S FSQ. Preconfigured for WCDMA, with one RF path and an analyzer frequency range up to 26 GHz, both instruments together test WCDMA base stations in line with the 3GPP standard. The R&S FSMU-W can be upgraded at any time with a second RF path, a fading simulator and options for other 2G or 3G standards....

LISTED UNDER: Services, Calibration / Test

Multi-Standard Test System

February 25, 2005 7:51 am | Product Releases | Comments

Aeroflex launches a development and conformance test system that can test applications running on all major cellular phones including GSM/EGPRS and W-CDMA. The Aeroflex Air Interface Monitor Emulator/Applications Test (AIME/AT) conformance test system can be used for all major phone types. The AIME/AT test system can be used for live network testing or in conjunction with any of Aeroflex's GSM, W-CDMA, and CDMA protocol test systems for det...

LISTED UNDER: Services, Calibration / Test

Test and Measurement Catalog

February 4, 2005 10:49 am | Product Releases | Comments

Keithley announces the availability of its 2005 Test and Measurement Products Catalog. This desktop reference guide offers details and specifications on Keithley's general-purpose and sensitive sourcing and measurement products, DC switching, RF switching and measurement, data acquisition solutions, semiconductor test systems, and optoelectronics test hardware....

LISTED UNDER: Services, Calibration / Test
Advertisement

Mobile Radio Tester

January 31, 2005 10:26 am | Product Releases | Comments

To be prepared for the future of mobile radio, the Universal Radio Communication Tester R&S CMU200 from Rohde & Schwarz provides two new functionalities. It enables testing of applications for CDMA2000, (E)GPRS, and WCDMA, and also generates high-speed downlink packet access signals in non-signaling mode and evaluates them in the uplink....

LISTED UNDER: Services, Calibration / Test

SOC Test Solution

December 23, 2004 8:04 am | Product Releases | Comments

Agilent introduces an automated test solution for functional, at-speed test for testing high-speed, system-on-a-chip (SOC) devices. Part of the Agilent 93000 SOC Series, this high-speed I/O solution enables functional testing of high-pin-count devices, such as next-generation PC chipsets up to speeds of 3....

LISTED UNDER: Services, Calibration / Test

Conformance Testing

December 23, 2004 8:04 am | Product Releases | Comments

VeriWave announces automated conformance tests for IEEE 802.11 APs (Access Points) and clients. The test suites execute on VeriWave's WaveTest™ Traffic Generator/Performance Analyzer. The two conformance test suites address the complexity associated with the development of 802.11 devices. The Client UNH-IOL 802....

LISTED UNDER: Services, Calibration / Test

Wireless Laptop Test Solution

December 23, 2004 7:57 am | Product Releases | Comments

Azimuth Systems announces its W-Series wireless laptop test solution that allows the performance and scalability of laptop PCs with embedded wireless communications to be automatically validated. The laptop test solution extends the Azimuth W-Series , the industry's first Wireless LAN testing platform, by incorporating standard, off-the-shelf laptops with embedded Wi-Fi into the standard testing process....

LISTED UNDER: Services, Calibration / Test

Managing RFIC Test Challenges for WLAN Services

December 23, 2004 7:33 am | by Cost-effective, high-performance, reconfigurable test systems are the mantra for next generation WLAN RF components. John Lukez | Product Releases | Comments

The rapid growth of WLAN systems has created extraordinary challenges for RFIC testing. The emergence of WLAN standards is driving key performance characteristics such as channel bandwidths and data rates to unprecedented levels. To meet evolving requirements in WLAN and communications services, IC manufacturers need cost-effective, high-performance ATE systems that are easily upgradeable, maintain high-accuracy, and boost test throughput....

LISTED UNDER: Services, Calibration / Test

Automated Test Solution

December 16, 2004 6:38 am | Product Releases | Comments

Agilent introduces an automated test solution for functional, at-speed test that reduces the cost of testing high-speed, system-on-a-chip (SOC) devices to the lowest in the industry. Part of the Agilent 93000 SOC Series, this complete high-speed I/O solution enables functional testing of high-pin-count devices, such as next-generation PC chipsets up to speeds of 3....

LISTED UNDER: Services, Calibration / Test

Wi-Fi Testing Using a Cabled RF Environment

November 23, 2004 11:17 am | Product Releases | Comments

An elegant alternative to homegrown test environments for wireless systems. By Fanny Mlinarsky, Azimuth Systems As Wi-Fi technology matures, wireless LANs are moving from the relatively tolerant SOHO market to the demanding enterprise — a market where high network performance is needed to support mission-critical applications, a large number of network users, and a diversity of network elements....

LISTED UNDER: Interconnect, Cables | Services, Calibration / Test

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading