Advertisement

Customizable Broadband and WiMAX Filters

May 26, 2009 6:59 am | Product Releases | Comments

Sangshin Elecom offers fully customizable Broadband and WiMax filters. A leading supplier of ceramic filters, Sangshin offers over 700 designs in these areas with frequency coverage from  6.0GHz in both narrow and ultra wide bandwidths. Configurations range from 2.5 mm through 6 mm heights and from 2 to 6 poles....

LISTED UNDER: Filters, IC

Broadband Filters and ADC Drivers Offer High Performance

January 14, 2009 9:43 am | Product Releases | Comments

Linear Technology introduces its family of five single and dual high performance, wide bandwidth lowpass active filter/ADC driver amplifier products that provide solutions in a small form-factor for filtering applications in broadband wireless communications and signal processing equipment. The filter's lowpass cut-off frequency up to 2....

LISTED UNDER: Filters, IC

Filters/ADC Drivers Target Broadband Wireless Equipment

November 21, 2008 10:08 am | Product Releases | Comments

Linear Technology's LTC660x family of broadband active filters/ADC drivers perform in broadband wireless communications and signal processing equipment. The dual-channel programmable 2.5-MHz LTC6603 offers adjustable of fixed gain, frequency control over a 100:1 frequency range, max. amplitude mismatch of ±0....

LISTED UNDER: Filters, IC
Advertisement

Power Quality Filters Offer Low Harmonic Distortion

September 22, 2008 12:45 pm | Product Releases | Comments

Schaffner’s FN 3410 and FN 3412 Series ECOsine™ power quality filters reduce total harmonic current distortion (THID) to less than 5% in three-phase power electronics with six-pulse rectifier front ends, such as AC or DC motor drives. The FN 3410 Series operates on 50 Hz grids with power ratings from 4 to 160 kW over a voltage range from 380 to 500 V....

LISTED UNDER: Filters, IC

Cavity Filters Use EM Software

September 16, 2008 11:38 am | Product Releases | Comments

MtronPTI’s WiMAX cavity filter series utilizes a re-configurable design platform fully modeled in EM (electromagnetic) simulation software in passband center frequencies from 2.30 to 2.70 GHz and a bandwidth range from 0.04% to 0.2% 1 dB. The device allows for use in Rx ?and/or Tx modes and multiple cross-coupling schemes with four transmission zeroes placed on either side of the passband....

LISTED UNDER: Filters, IC

Design Complex Filters Without Writing Software

September 16, 2008 11:38 am | Product Releases | Comments

Quickfilter Technologies. Inc. has released QuckfilterPro-4A Software, version 4.0. The software is used to design filters that will be implemented in Quickfilter's QF4A512 programmable signal converter IC. Version 4.0 provides users with an enhanced user interface, several new filter types, a free-form filter drawing tool and the ability to create inverse transfer functions with the click of one button....

LISTED UNDER: Filters, IC

BAW Filters Enable WiMax and WLAN Co-Existance

August 25, 2008 7:57 am | Product Releases | Comments

Skyworks Solutions, Inc. announces its bulk acoustic wave (BAW) filters for customer premise equipment (CPE) to allow co-existence between wireless local area networks (WLAN) in the home and enterprise, and WiMAX networks which cover wider areas including neighborhoods and cities. Since both networks operate at very closely spaced frequency bands, these BAW filters reject the interfering frequencies while allowing the desired signals to pas...

LISTED UNDER: Filters, IC

Integrated EMI Filters and the Need for More Bandwidth

December 12, 2007 5:36 am | Product Releases | Comments

In previous generations of cell phones, when the design called for more data to be moved around, the solution was to add more data lines. Only a handful of data lines were sufficient at first, since there was only basic numeric data to be displayed and data rates were rather low. We all remember the old analog flip phones with their LED displays, you pushed the keypad and a digit appeared....

LISTED UNDER: Filters, IC
Advertisement

Thin Film Low Pass Filters

November 15, 2007 7:48 am | Product Releases | Comments

State of the Art (SOTA), Inc. announces an addition of thin film low pass filters to its high frequency product line. --> State of the Art (SOTA), Inc. announces an addition of thin film low pass filters to its high frequency product line. Sub-miniature case size (0.150 × 0.100 × 0.025) low pass filters (LPF) are available on 99% alumina substrate constructed using high stability thin film planar technology, 50 ohm terminations a...

LISTED UNDER: Filters, IC

Brand Feed Through Filters and Capacitors

November 8, 2007 7:41 am | Product Releases | Comments

Tyco Electronics Corporation introduces a line of CORCOM brand feed through filters and capacitors. These filters are suitable for AC applications ranging from 10 to 300 am/s, and DC applications ranging from 10 to 200 am/s. They are designed for high frequency applications such as servers, base stations, routers, power supplies and telecom....

LISTED UNDER: Filters, IC

Cooling Filters

October 17, 2007 6:36 am | Product Releases | Comments

W. L. Gore & Associates, Inc. announces an addition to its line of telecommunications products for improving system reliability. The GORE® Cooling Filters use ambient air to cool electronic components in outdoor enclosures and Gore’s membrane technology to protect sensitive electronics from extreme environments where they may encounter corrosive particles, sand or salty environments....

LISTED UNDER: Filters, IC

COTS Single Line Feed-thru EMI Filters

October 17, 2007 6:36 am | Product Releases | Comments

Spectrum Control, Inc. offers COTS single line feed-thru EMI filters that are commercially equivalent to M15733-PRF/72, M15733-PRF/73 and M15733-PRF/74. These filters are offered in both AC and DC models with customizing options available, and they are suitable for the military and aerospace industries....

LISTED UNDER: Filters, IC

Waveguide Low-Pass Filters

October 17, 2007 6:36 am | Product Releases | Comments

Link Microtek introduces its AMQ-LP1 series of waveguide low-pass filters that provide a rejection of better than 100 dB, falling to 70 dB at band edges. The filter series comprises five standard parts, using waveguide sizes of WR340, WR137, WR112, WR90 and WR75 to deliver cut-off frequencies of 2....

LISTED UNDER: Filters, IC

EMC Filters for Medical Applications

October 17, 2007 6:36 am | Product Releases | Comments

EPCOS’ SIFI-F (B84111FM) compact two-line filters are available in a medical version for applications where low leakage current is a critical factor. They have a low maximum leakage current of 2 mA, and they offer desirable suppression of symmetrical and asymmetrical interference. The SIFI-F, along with the larger SIFI-G and SIFI-H, is designed for the climate category of 㪱°C up to +100°C....

LISTED UNDER: Medical | Filters, IC

RF Filters

July 2, 2007 1:02 pm | Product Releases | Comments

Q Microwave, Inc. announces a line of RF filters customized for RF and microwave system requirements operating over the range of 500 MHz to 6 GHz. The filters are available in low-cost, surface-mount technology (SMT) package designs for high reliability and ease of assembly. These filters are good solutions for use in identification friend or foe (IFF) systems or any other applications requiring rugged and robust filter designs in demanding...

LISTED UNDER: Filters, IC

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading