Product Releases
Subscribe to Wireless Design and Development

Quad LVDS Driver And Receiver ICs

December 10, 2001 3:33 am | Comments

Adding to its broad array of Interface and Logic solutions, Fairchild Semiconductor International released five new high performance Quad LVDS (Low Voltage Differential Signaling) devices. The quad drivers and receivers complement Fairchild's existing portfolio of LVDS devices. By utilizing Fairchild's LVDS offerings, customers obtain products that are fully compatible with existing industry solutions and can offer significant performance...

One-Gigabit Nand Flash Memory Device

December 10, 2001 3:33 am | Comments

Toshiba America Electronic Components with its parent company, Toshiba Corporation (Toshiba) raised the bar for memory density and lowered cost-per-bit with its 1-gigabit (Gb) multi-level cell (MLC) NAND electrically erasable programmable read-only memory (EEPROM). Co-developed by Toshiba and Sunnyvale, Calif....

High Current Jumper

December 10, 2001 3:33 am | Comments

Offering power supply designers a low-profile surface mount alternative to bulky through-hole designs, the TT electronics IRC Advanced Film Division recently developed a jumper with extremely low resistance ideally suited for high-current applications. These jumper resistors feature inductance ratings less than 0....


N-Type Attenuators

December 10, 2001 3:33 am | Wireless Design & Development | Comments

MECA's compact 611 series N-Type coaxial attenuators cover all commercial wireless bands from DC - 2 GHz and are available in attenuation values from 0 - 20 dB in 1 dB increments. Standard attenuation values of 3, 6, 10 and 20 dB are in stock ready for immediate shipment; delivery of other values is stock to 2 weeks....

Rugged Original Card

December 10, 2001 3:33 am | Comments

FCI Electronics is pleased to announce the ROCARD™ kit, tailored to meet the wireless application needs of customers. The new product consists of card shields with an open back-end of 5 mm that allows for the attachment of an antenna extension or a customized I/O solution. The new card kit is available in a Type II format, in CardBus (33 Mhz, 32-bit databus) and a new standard version (10 Mhz, 16-bit databus)....

Snap-in Aluminum Electrolytic Capacitor

December 10, 2001 3:33 am | Comments

Because of the continued push for higher energy density and smaller size in motor drives, UPS systems and power supplies, there is a growing demand for increased ripple-current capability in bus capacitors. It's the bus capacitors that take the heat from equipment downsizing because the new designs impose more ripple current per capacitor and use fewer or smaller capacitors....

Operational Amplifiers

December 10, 2001 3:33 am | Comments

Microchip Technology announced the MCP602X family of op amps for low current, high-performance applications. The MCP602X, rail-to-rail input and output op amps, offer designers a cost-effective way to improve performance and increase the operational life of battery powered systems for audio processing, communications, test and medical equipment applications....

Base Station Synchronization in Wireless Networks: Cellular, Fixed Broadband, Wireless LAN

December 6, 2001 5:25 am | Comments

Datum-Irvine Wireless networks come in many different flavors, from the familiar cellular phone network to fixed broadband to wireless LANs. Although each is a very different application they are all dependent on a common base station architecture. The base station, (also called cell site, picocell, or access point depending on the technology) is the connection point between the wired and wireless world....


Multi-Monitor Support Added to Logic Analyzer

December 5, 2001 4:00 am | Comments

Tektronix announced important new advancements to its flagship platform for digital signal integrity. Leading computer and embedded system makers are developing increasingly complex digital devices, which equates to more signals on a logic analyzer's screen at one time. Until now, engineers have been limited to one monitor, scrolling up and down constantly to compare data, and toggling between application windows to work concurrently with t...

Single Chip Interface Circuit

December 3, 2001 3:38 am | Comments

Ericsson Microelectronics' PBM39705/3 single chip Analog Receive/Transmit Interface Circuit (ARTIC) provides the receiving and transmitting, echo cancellation and terminating functions needed for the implementation of an ADSL transceiver. In response to industry demands for this type of product, power consumption is minimized by the line driver architecture and by a design optimized for ADSL....

Termination Arrays

December 3, 2001 3:38 am | Comments

Providing design engineers with high performance surface mount resistor networks for termination applications, TT electronics' IRC Advanced Film Division recently introduced a series of arrays in ball grid packages. These high density networks, designated the CHC Series, feature power ratings from 0....


December 3, 2001 3:38 am | Comments

Maxim Integrated Products introduces the MAX3362 high-speed RS-485/RS-422 transceiver. This device is packaged in an 8-pin SOT, saving 70% board space over the industry-standard SO. In addition, the MAX3362 features hot-swap circuitry, eliminating data glitches during hot insertion. This circuitry holds the RS-485/RS-422 lines in a high-impedance state during startup to avoid sending false data....

High Performance Base Station Antennas

December 3, 2001 3:38 am | Comments

Radio Waves announced the availability of new high performance base station antennas in the ISM, 3.5 GHz, and UNII bands. These 90-degree sectors offer exceptional sidelobe roll-off characteristics. With a half power beamwidth (HPBW) of 90 degrees, the roll off is more than 25 dB at ± 135 degrees, and the Front-to-Back ratio is greater than 35 dB....

36 to 40 GHz GaAs MMIC Up-Converter

December 3, 2001 3:38 am | Comments

Mimix Broadband announced the introduction of a gallium arsenide (GaAs) monolithic microwave integrated circuit (MMIC) up-converter, which is comprised of a pair of sub-harmonic mixers configured to form an image reject mixer. This is followed by a two stage low noise amplifier (LNA). The image reject mixer removes the need for a bandpass filter after the mixer to suppress the unwanted sideband....

HF OCXO in Small, SMD Package

December 3, 2001 3:38 am | Comments

Temex announces the development and mass production of the new standard OCXO of the HF series: the QEO HF 94 @ 100 MHz. The size of the SMD package is 25 × 22 × 10 mm (1 × 0.86 × 0.4 inches). Available power supplies are 12.5 and 3.3 V. Typical performances are a stability of 0 to +70°C = ± 0....


You may login with either your assigned username or your e-mail address.
The password field is case sensitive.