Advertisement
Product Releases
Subscribe to Wireless Design and Development

512 Megabyte Memory Card

April 6, 2001 5:21 am | Comments

SanDisk introduced a 512 megabyte (MB) CompactFlash™ (CF) memory card. The standard CF Type I card features high capacity. The company also introduced a high-capacity 128MB SmartMedia memory card. SanDisk, which also added 256MB and 384MB standard CompactFlash cards to its product lineup, is targeting the new high-capacity cards primarily at the new three and four megapixel, high-resolution digital cameras and Internet music players....

Ceramic Packages for Applications From DC to 50 GHz

April 6, 2001 5:21 am | Comments

StratEdge's SE50 line of standard off-the-shelf designs handle packages operating between DC and 50 GHz. These commercial packages can withstand the heavy electrical and thermal demands required to protect the broadband and power MMIC amplifiers needed for LMDS, point-to-point, and point-to-multipoint technologies....

100 Watt, 0.3 - 30 MHz Power Amplifier

April 6, 2001 5:21 am | Comments

LCF Enterprises has developed an economically priced, high performance 100 Watt RF Power Amplifier that covers the frequency range from 0.3 MHz to 30 MHz and 45 dB of gain. Features include automatic current limiting, forced-air cooling, current meter, over-current, and thermal protection. The amplifier is also available as a DC Module in a small, high efficiency package....

Advertisement

Electronic Grade Foam Protects Components

April 6, 2001 5:21 am | Comments

E-A-R Specialty Composites has developed a non-silicone formulation if its highly damped, slow-recovery CONFOR® foam, specifically to address the shock protection needs of today's miniaturized computers, hand-held electronics, and personal digital assistants. Used as shock pads, spacers, or snubbers, energy-absorbent CONFOR CF-45E foam protects delicate components from shock and vibration, with no silicone off-gassing....

Wireless Platform Increases 3G Radio Channel Density

April 6, 2001 5:21 am | Comments

Blue Wave Systems launched the ComStruct™ CPCI/C6800, which will enable third generation (3G) developers to realize a greater than four times increase in base station transceiver (BTS) channel density, thereby enhancing network capacity and accelerating 3G rollout. The Commercial-Off-The-Shelf CompactPCI® platform is based on the recently launched TMS320C6415 and TMS320C6416 digital signal processors (DSPs) from Texas Instruments Inc...

Lithium Batteries For Compact Designs

April 6, 2001 5:21 am | Comments

To meet the growing demand for smaller, lighter and high capacity rechargeable battery solutions, Toshiba America Electronic Components(TAEC) announced the addition of Advanced Lithium Batteries (ALB) to its line-up of rechargeable batteries. Traditionally, conventional battery structure has mandated that batteries maintain a thickness of no less than 5 to 6 mm....

Family of RF ICs Customized for Bluetooth

April 6, 2001 5:21 am | Comments

Toshiba America Electronic Components (TAEC) announced that it has expanded its family of RF integrated circuit (IC) packages called Cell Packs. These new Cell Packs offer designers a quick and easy way to implement a variety of important functions required for mobile communications products and Bluetooth™-enabled devices....

Power Divider/Combiners

April 6, 2001 5:21 am | Comments

MECA recently introduced the "V-Line" family of isolated power divider/combiner. These dual-band (0.800 - 2.000 GHz) dividers are ideally suited for low-cost, high-performance applications with shipment from stock to meet JIT requirements. The 802-2-1.400 (2-way, SMA-Female) measures 1....

Advertisement

MMIC DPDT Diversity Switch

April 6, 2001 5:21 am | Comments

Hittite Microwave introduces a C-band DPDT switch that operates between 5.0 and 6.0 GHz. The HMC393MS8G features 1.2 dB insertion loss and provides P1 dB of 34 dBm with 5 volts bias. This design can operate as an integrated antenna diversity and transmit/receive switch for the HiperLAN and UNII radio platforms providing 20 dB of isolation between antennas and between Tx and Rx ports....

Personal Analyzer Charger

April 6, 2001 5:21 am | Comments

iTECH (Intelligent Technologies LLC) announces the release of IQpac®— personal analyzer charger to the land mobile radio market. IQpac is an addition to iTECH's IQ® line of battery charger/analyzer/conditioners. IQpac features tri-mode operation: "charge,"" quick analyze" to analyze and condition while charging and "spec analyze" to test batteries to specification standards....

Wireless Networking Chip

April 6, 2001 5:20 am | Comments

Philips Semiconductors, a division of Royal Philips Electronics announced the first in a new generation of broadband wireless integrated circuits (ICs) designed to enable high speed, wireless networking in the enterprise, small office and home markets. Philips Semiconductors' new IC, the SA2400, is a fully integrated Zero-IF single-chip radio designed for applications in the IEEE 802....

Upconverter/Driver Integrated Circuit

April 6, 2001 5:20 am | Comments

Maxim Integrated Products announces the MAX2307 miniature upconverter/driver IC with variable gain. It is designed for Japanese N-CDMA and PDC 900 MHz applications in the 900 MHz frequency band. The device features ultra-low current consumption and very small size. Implementation cost is optimized by replacing a SAW filter with a low-cost inductor....

Low Noise Amplifiers

April 6, 2001 5:20 am | Comments

Fujitsu Compound Semiconductor, Inc. (FCSI) announces the expansion of their Low Noise Amplifier (LNA) MMIC product line. FCSI is introducing two new millimeter-wave, high power MMIC amplifier products covering the 24 to 40 GHz frequency band with output power of up to 9 dBm. These new devices are designed for point-to-point or point-to-multipoint radio link and Local Multipoint Distribution System (LMDS) applications....

Vector Network Measurement System

April 6, 2001 5:20 am | Comments

Anritsu Company, a provider in high-performance test and measurement solutions, introduces the MS4600/4B option for its Scorpion® MS46XX RF Vector Network Measurement System (VNMS). The MS4600/4B extends the noise figure frequency of the VNMS to 6 GHz so it can analyze low noise amplifiers (LNAs) and other devices covering the 5....

Power Amplifier Test System

April 6, 2001 5:20 am | Comments

Anritsu Company, a provider in high-performance test and measurement solutions, has enhanced its ME7840A Power Amplifier Test System (PATS) with additional measurement capability, making it the most comprehensive solution for real-time simultaneous tuning of power amplifier parameters. The ME7840A can now conduct ACPR, IMD, PAE, compression, harmonics, and S-parameter measurements with a single connection, thereby creating a turnkey solutio...

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading