Advertisement

6-Volt VRLA Battery for High Rate Discharge Applications

February 2, 2004 8:06 am | Product Releases | Comments

EnerSys expands its DataSafe NPX line of VRLA batteries with the addition of the NPX 35-6 battery for applications which require high power for short intervals. The battery provides 30% more power than conventional batteries with an equivalent footprint and voltage and was designed to meet the high energy needs of a wide range of UPS and general electronics applications....

LISTED UNDER: Power, Batteries | Power, Battery

Battery Charger

September 2, 2003 8:42 am | Product Releases | Comments

Linear Technology introduces the LTC4002, a standalone switch-mode Li-Ion battery charger with an operating supply as high as 24 V. Low 4.7V input supply and low dropout operation of the IC guarantees continuous charging of 4.2 V Li-Ion batteries from 5 V wall adapters. For safety and autonomous charge control, the LTC4002 includes features such as automatic shutdown, battery preconditioning, battery temperature sensing, end-of-charge indic...

LISTED UNDER: Power, Batteries | Power, Battery

Battery Chargers

July 30, 2003 9:51 am | Product Releases | Comments

Cell-Con's lead acid battery chargers are designed to work with batteries that have been discharged to the manufacturers recommended 1.75 V per cell (5.25 V for a 6 V battery and 10.5 V for a 12 V battery). If the batteries have been discharged below that point or if the battery is near the end of its service life, it may draw more current than the charger it is designed for....

LISTED UNDER: Power, Chargers | Power, Batteries | Power, Battery
Advertisement

Battery Clips

July 30, 2003 9:51 am | Product Releases | Comments

Keystone Electronics introduces a low profile battery clip for AAA and N cells. The clip features a "flow hole" SMT solder tail designed to increase joint strength. The .010 inches thick nickel-plated spring steel clip is designed to securely retain cells and withstand shock and vibration....

LISTED UNDER: Power, Batteries | Power, Battery

Dual Channel Battery/Charger Simulator

July 2, 2003 9:47 am | Product Releases | Comments

Keithley introduces its Model 2306-VS dual channel fast transient power supply with external triggering. Designed to meet the evolving test needs of handset and cellular component manufacturers, the Model 2306-VS allows externally triggered output voltage level changes with additional measurement capability....

LISTED UNDER: Power, Batteries | Power, Battery

Li-Ion Battery Charger

May 30, 2003 11:38 am | Product Releases | Comments

The LTC4056 is a linear Li-Ion battery charger controller in a ThinSOT™ package. The total solution occupies an area of less than 75 mm 2 and has a height of 1 mm. The LTC4056 targets systems that need to charge a 4.2 Li-Ion battery from a 4.5 V to 6.5 V input source with charge currents ranging from 200 mA to 700 mA....

LISTED UNDER: Power, Batteries | Power, Battery

Battery Contacts

March 28, 2003 9:42 am | Product Releases | Comments

These leaf-type battery contacts for snap-in mounting of AA batteries are high reliability devices feature spring tension, which provides low contact resistance while adjusting to any variations in battery length. Availability is in either leaf spring (negative, Part #590) or button (positive, Part #596)....

LISTED UNDER: Power, Batteries | Power, Battery

Battery Contact

March 28, 2003 3:51 am | Product Releases | Comments

Developed for portable electronic devices, the BC-501-1 SMT batter contact produces high-reliability spring contact due to its design. The free standing BC-501-1 contacts can be randomly placed on a circuit board. The BC-501-1 is manufactured from phosphor bronze flat wire with gold plating, 10 micro inches thick over nickel....

LISTED UNDER: Power, Batteries | Power, Battery
Advertisement

Battery System

February 25, 2003 12:07 pm | Product Releases | Comments

The PowerSafe DDm battery system provides long service life and excellent performance for a variety of applications that require large capacity valve-regulated batteries. The cell design of the DDm incorporates thick 0.25 inches positive plates for a long battery life of up to 20 years. The battery cells have welded epoxy, dual post seals that are 100% water bath tested in the factory....

LISTED UNDER: Power, Batteries | Power, Battery

Linear Battery Charger

December 26, 2002 8:56 am | Product Releases | Comments

The ISL6291 is a highly integrated linear battery charger for single cell Li Ion/Li Polymer powered handheld applications. ISL6291 provides a single output voltage of either 4.2 V or 4.1 V, 1% accuracy, required for safely charging Li based cells. The part is available in a 16-pin 5 × 5 mm QFN package....

LISTED UNDER: Power, Batteries | Power, Battery

Battery Connector

November 1, 2002 6:09 am | Product Releases | Comments

The Euro Battery Connector family (EBC), features technical innovations for ease of use and assembly for 80, 160, and 320 amp applications. Its design is intermatable with all existing DIN 43589-1 auxiliary contact systems currently installed. The EBC allows the voltage-key to remain in place when acid/air circulation is used....

LISTED UNDER: Power, Batteries | Power, Battery

Front Terminal Battery

November 1, 2002 6:08 am | Product Releases | Comments

The Powersafe VX100F series has a design life of 10 years at 40°C. The series includes positive plates made of pure lead for enhanced corrosion resistance, a polycarbonate/ABS blend used for the battery's case and cover to provide added mechanical strength and thermal stability, and a high quality compression grommet post seal....

LISTED UNDER: Power, Batteries | Power, Battery

Lithium Battery Protection Module

September 11, 2002 5:17 am | Product Releases | Comments

The Panther Lithium-Battery Protection Module is for use in Li-ion and Li-polymer single-cell applications. The miniature module improves the operating life of one-cell rechargeable battery packs. It provides complete lithium-battery protection with no external components. The Panther module is sized to connect to most Li-polymer cells without extra connecting boards or flex....

LISTED UNDER: Power, Batteries | Power, Battery

Battery Packs

September 11, 2002 5:17 am | Product Releases | Comments

These custom battery packs feature special brackets or stand-offs to save space inside product packages or can incorporate snap-on plastic cases to create space outside, while maintaining a clean, streamlined appearance. Primary chemistries such as alkaline, nickel-cadmium, nickel-metal-hydride, lithium ion, and LMNO 2 are available....

LISTED UNDER: Power, Batteries | Power, Battery

Battery Servicing Tool

June 4, 2002 9:36 am | Product Releases | Comments

DataFX is a versatile instrument for aircraft battery and cell monitoring. Features include a design with a large display screen for viewing up to 22 cell voltages simultaneously, print capabilities that eliminate the need for manual recording, and self-calibration. DataFX quickly and accurately scans the battery's cells during charge and discharge, measuring cell voltages at varying intervals, and displaying the results on the front panel ...

LISTED UNDER: Power, Batteries | Power, Battery

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading