The Source on Design and Technology for the Wireless and RF Engineer
Subscribe to Wireless Design and Development All
View Sample

FREE WDD Email Newsletter

Dual-Band Power Amplifier

June 10, 2002 11:26 am | Product Releases | Comments

The RFS P5910 is a single-chip power amplifier targeted for network interface cards (NIC) that can address both 802.11a and HiperLAN/2 at 5 GHz as well as 802.11b and 802.11g at 2.4 GHz. The part is suitable for orthogonal frequency division multiplexing (OFDM) technology in the two U-NII sub-bands from 5....

Test Path to 3G Leads to Flexibility and Multi-standard Instrumentation

June 6, 2002 10:43 am | Product Releases | Comments

By Yuenie Lau, Anritsu Company The migration to 3G (Figure 1) is littered with a variety of standards, none of which is the definitive answer that will be used globally. As we have gone from 2G to 2.5G formats, designers have been faced with the challenge of developing products for multiple standards....

Miniature Cavity Filter

June 4, 2002 9:36 am | Product Releases | Comments

Model W2641F bandpass filter offers very sharp rejection to nearby interfering signals from radar and other ISM inband services. The 80 MHz bandwidth allows very high data rates while offering a low 0.5 dB insertion loss. With a 1.4:1 VSWR, the filter permits the use of low noise amplification to overcome cable loss....


LSE Free Film

June 4, 2002 9:36 am | Product Releases | Comments

MACbond® IB-2180 is a double-side tape version of MACtac's low surface energy (LSE) free film, IF-2090, which is able to bond to low energy surfaces. The IF-2090 series is ideal for bonding to polypropylene, polyethylene and powdered-coating surfaces. IB-2180 uses the LSE adhesive system combined with a polyester film carrier for dimensional stability....

Low Voltage Diode Array

June 4, 2002 9:36 am | Product Releases | Comments

The SR2.8 steering diode array and TVS combination protection device has low voltage (2.8 V) and low capacitance (5 pF). Designed to protect two line pair, or four data or transmission lines, the SR2.8 is ideal for low voltage circuit applications where operating currents are less than 100 mA. In addition, the SR2....

Shield Bead Ferrite Chokes

June 4, 2002 9:36 am | Product Releases | Comments

The Prem SPG-100 and SPG-101 are designed to attenuate EMI and other unwanted signals in a circuit without contributing to power losses at lower frequencies or DC. These two units offer vertical-mount arrangement. Impedances range from 20 Ω to 50 Ω and are obtained over frequencies ranging from 1....

Op Amps

June 4, 2002 9:36 am | Product Releases | Comments

The MIC920 and MIC921 are decompensated derivatives of the MIC918 and MIC919. Decompensation enables the MIC920 and MIC921 to achieve a higher slew rate and gain bandwidth product for the same power consumption while still maintaining unity-gain stability. The MIC920 has a gain-bandwidth product of 80 MHz and the MIC921 has a gain-bandwidth product of 45 MHz....

Two Piece Fastener

June 4, 2002 9:36 am | Product Releases | Comments

The "Dome and Tack" molded, two piece Nylon fastener features a locking mechanism, which is totally enclosed to prevent tampering. These "Dome and Tack" fasteners are for use in a pre-punched hole, and there will be no sharp exterior edges after the part is assembled....


L-Band VCO

June 4, 2002 9:36 am | Product Releases | Comments

The V602ME20 generates frequencies between 1580 and 1810 MHz within 0.25 to 4.75 V DC of control voltage. This VCO exhibits a clean spectral signal of – 100 dBc/Hz, typically, at 10 kHz from the carrier and is ideal for terrestrial applications operating from a 4.5 V DC source while drawing 10 mA....

AC/DC Power Supplies

June 4, 2002 9:36 am | Product Releases | Comments

Model DMS-PS-CM Series of AC/DC instrumentation power supplies are ideal for driving modern transducers, digital panel meters, operational amplifiers, and data acquisition components. The series accepts universal AC inputs (85 - 264 V AC @ 47 - 63 Hz) and deliver +5 V DC, +12 V DC and/or +24 V DC outputs from single, dual or triple-output configurations....


LDO Regulators

June 4, 2002 9:36 am | Product Releases | Comments

A family of three low-voltage, high current low-dropout regulator (LDO) ICs are available from Micrel. They are ideal for powering low-voltage ICs where real estate is limited but performance requirements are high. Manufactured in S-Pak packaging the 3-Amp MIC3730X LDOs provide 1.5 , 1.8 V, or 2....

High Energy LEDs

June 4, 2002 9:36 am | Product Releases | Comments

The 3 mm (T1) white discrete LED maximizes the options available to engineers and designers. Part number L120CW3KB-22D, water-clear, 8000K 3mm (T1) white LED integrates a SiC/GaN diode with optical grade epoxy to produce a 3500 mcd illumination at 20 mA that is visible even in direct sunlight. The 3mm (T1) features a 22° viewing angle and sturdy leads for reliability in wire-wrap/through-hole PCB applications....

Class 2 Transformer

June 4, 2002 9:36 am | Product Releases | Comments

ATC-Frost introduced a new class 2, 95 V A transformer with 120 V input voltage and 24 V output. It is also available in other voltages. All are UL and cUL approved to UL1585....

Low Capacitance Array

June 4, 2002 9:36 am | Product Releases | Comments

The SRV05-4 array features ultra low capacitance (3 pF) per line. Designed for protection against Electrostatic Discharge (ESD), the SRV05-4 clamps the effects of electrical fast transients on the power bus. The SRV05-4 is ideal protection for 3G cellular handsets. Rated for 5.0 V applications, the SRV05-4 combines eight low capacitance steering diodes for up to four individual data or transmission lines and one TVS diode for the power bus....

600 W Power Supply

June 4, 2002 9:36 am | Product Releases | Comments

The Quick-Set PowerCassette , with model numbers starting with PCH-S and TPCH-s, come in both chassis mount and hot-swap versions. The units provide up to six outputs, including a 5 V DC, on-ampere independent standby output. Maximum continuous power is 600 watts, and available output voltages are from 1....


You may login with either your assigned username or your e-mail address.
The password field is case sensitive.