Advertisement
The Source on Design and Technology for the Wireless and RF Engineer
Subscribe to Wireless Design and Development All
View Sample

FREE WDD Email Newsletter

Video Transient Switch

May 30, 2003 11:38 am | Product Releases | Comments

Model No. SWN-1140-3DR-STD with options 218, B08, and B01-12V is a 2.0 - 18.0 GHz low video transient SP3T switch. FSWR is 2:1. Isolation is 60 dB. Insertion loss is 3.5 dB. Switching speed is 20 nsec rise/fall time. On/off delay is 70 nsec. RF power is +20 dBm and TTL control logic (0) on. www....

Log Video Amplifiers

May 30, 2003 11:38 am | Product Releases | Comments

PMI Model No. SDLVA-07103-70-LA3 is a 750 MHz to 1.25 GHz frequency range (0.3 to 2.0 GHz units available) successive detection log video amplifier (SDLVA). This SDLVA provides up to 80 dB of dynamic range in 25 nS speed and with low AM/PM conversion and a nominal 20 MHz video bandwidth. The log linearity is ± 1....

Solid State Attenuator

May 30, 2003 11:38 am | Product Releases | Comments

The VVAN-2535-60SP-NS30 is a 2.5 - 3.5 GHz, 60 dB dynamic range high speed voltage variable solid state attenuator with 1.25 - 1.75 dB insertion loss. VSWR is 1.8:1. Attenuation flatness is ± 0.3 dB maximum. Attenuation accuracy is ± 3.0 dB maximum. Transfer function is 10 dB/Volt. Switching speed is 700 nS....

Advertisement

Selectable Oscillators

May 30, 2003 11:38 am | Product Releases | Comments

Elcom introduces an ultra low phase noise, ruggedized, selectable oscillator, designed for SATCOM converters and wideband receiver applications. The SFDRO series frequency phase locked oscillators has an RF output frequency of 0.5 to 26 GHz. RF output power is +12 to +15 dBm. RF output impedance is 50 Ohms....

C-Drive Amplifiers

May 30, 2003 11:38 am | Product Releases | Comments

Newport's C-Drive amplifiers is comprised of a DC brush servo amplifier (CDR-DCB) and a stepper motor amplifier (CDR-STEP), which both operate from +48 V DC power. MOSFET output stages deliver four-quadrant power for bi-directional acceleration and deceleration of motors. Analog command input signals are industrial standard ± 10 V DC for DC brush motor control....

Voice CODEC Chip

May 30, 2003 11:38 am | Product Releases | Comments

The W681511 chip is a single channel voice CODEC IC featuring low power (10 μA and 100 nA typical power consumption in standby and power down modes) and 4.5 to 5.5 V single supply voltage. The chip is compatible with Motorola MC14LC5480 with minor differences. The chip is offered in 20 pin SOP packaging....

Load Switches

May 30, 2003 11:38 am | Product Releases | Comments

Siliconix incorporated, a subsidiary of Vishay, announced a family of TrenchFET power MOSFETs build on P-channel technology. The family of devices can be used as load switches and help to reduce power consumption and the board area required for power components in cell phones, PDAs, and other compact, battery-operated products....

ISM Transceiver

May 30, 2003 11:38 am | Product Releases | Comments

The XE1202 ISM-band transceiver is now offered with an extended voltage range from 2.4 V to 3.6 V. With an RSSI wake-up time down to 1 ms, the XE1202 also minimizes power consumption, as the receiver remains active when a signal is present for it to receive. The XE1202 can operate in 868 - 870 MHz, 902 - 928 MHz, and the 433 MHz frequency bands....

Advertisement

Test Solution

May 30, 2003 11:38 am | Product Releases | Comments

The Agilent Signal Studio for 1xEV-DV and cdma200 software (E4438C-414) works with the Agilent E4438C ESG vector signal generator, giving mobile chipset designers a flexible test and verification tool based upon 3GPP2 standards. The software application includes four 1xEV-DV forward link channels: two short-duration, fully coded packet data channels (PDCH) and two real-time packet data control channels (PDCCH), in addition to forward and re...

RFID Chips

May 30, 2003 11:38 am | Product Releases | Comments

The EM4222 is a UHF chip that is optimizes to yield the minimum die area and cost. The EM4222 chip is a Read-Only UHF and Microwave (300 MHz to 2.45 GHz) single chip solution with a small footprint. Depending on the chip programming, tags can be red to speeds between 0.5 m/s and 100 m/s, while the maximum number of tags that can be read per second is 240 (average tag ID reading rate is nearly 200 tags per second)....

Probe Card

May 30, 2003 11:38 am | Product Releases | Comments

Cascade Microtech announces an RF multi-device test production probe card, the Pyramid™ Probe Card. The probe card allows wafer testing of multiple RF semiconductor wafers in production simultaneously. Pyramid Probe Cards are compatible with all brands of RF ATE equipment. Cascade Microtech's thin-film process, used to fabricate the probe cards, preserves the signal integrity of the RF lines that are being tested on multiple devices....

Storage Cards

May 30, 2003 11:38 am | Product Releases | Comments

MiniSD cards are designed to provide high capacity storage in an ultra-small removable card. The card is designed for the next generation of 2.5G and 3G mobile phones that require removable storage. The miniSD card will work in all devices that support an SD slot via an SD adapter that is included with each miniSD....

Protocol Stack Controller

May 30, 2003 11:38 am | Product Releases | Comments

The MCP2140 is a fixed speed 9600-Baud IrDA-Standard protocol stack controller. When used with the recommended discrete transceiver implementation, this device enables a complete IrDA-Standard wireless link (protocol handling plus transceiver) to be added to an embedded system while typically consuming less than 100 μA of additional current....

Dielectric Capacitors

May 30, 2003 11:38 am | Product Releases | Comments

AVX introduces a microwave single layer X7S dielectric capacitor (SLC) family. The dielectric, designated "Z", operates over an expanded temperature range of – 55°C to +125°C and offers tighter temperature characteristics of ± 22% as well. The series provides a range of dielectric constants from 2,500 to 15,000 and features dissipation factors less than 2....

AC Power Supplies

May 30, 2003 11:38 am | Product Releases | Comments

Elgar introduces the high frequency (up to 1000 Hz) and high voltage (up to 155/310 V AC) option for the CW Series AC power supply. All this is packaged in the same compact 3.5 inch high chassis. The CW Series is available in multiple power ranges with optional IEEE-488 or isolated analog remote programming....

TOPICS:

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading