Advertisement
The Source on Design and Technology for the Wireless and RF Engineer
Subscribe to Wireless Design and Development All
View Sample

FREE WDD Email Newsletter

HCMOS Compatible Oven Controlled Crystal Oscillator

February 27, 2002 9:34 am | Product Releases | Comments

The new C-W Model AGOF3S3 Crystal Oscillator from Connor Winfield was designed for base station and timing products designers. Its design approach keeps power consumption below 1.5 W at all times. Frequency calibration is ± 1.5 ppm at time of shipment. Output is HCMOS compatible and meets stability requirements of Stratum 3 applications....

Non-Isolated DC/DC Converters

February 27, 2002 9:34 am | Product Releases | Comments

Bel announced the first products from its recently formed Bel Power Products Division — the 3-module V7PB-06B Series of non-isolated DC/DC converters. These step down devices provide a single output of 1.5 V, 2.5 V or 3.3 V, with a 5 V input voltage, and maximum output current of 6 A. Moreover, full-load efficiencies of up to 94% ensure the utmost in reliability at costs of 30% to 40% below comparable products....

Bluetooth MultichipModule

February 27, 2002 9:34 am | Product Releases | Comments

Ericsson Microelectronics' ROK 101 007 is a complete Bluetooth multichip module (MCM) solution for cable replacement and poit-to-multipoint applications. It provides robust performance with up to 7 slave units and incorporates onboard firmware to provide a standardized Host Controller Interface (HCI) for host-based applications....

Advertisement

IrDA Protocol Stack Handler

February 27, 2002 9:34 am | Product Releases | Comments

Enhancing its Infrared product family, Microchip Technology introduced the MCP2155 IrDA® Protocol Stack Handler ideally suited for Data Communications Equipment (DCE) applications. The MCP2155 employs patented technology that embeds the complex IrDA protocol stack, including the Ir link access protocol (IrLAP), Ir link management-mux (IrLMP), tiny transport protocol (Tiny TP), IrComm layers (9-wire cooked service class) and portions of t...

Spectrum Analyzers for Remote Base Stations

February 27, 2002 9:34 am | Product Releases | Comments

Morrow Technologies has announced a new vector spectrum analyzer that enables an instrument to be permanently mounted in a cellular base station. The VC900 gives a service provider continuous remote access to important base station parameters such as adjacent channel power ratio, channel power, and statistical power measurements, as well as standard spectrum analyzer functions....

Surface Mount RF Module

February 27, 2002 9:34 am | Product Releases | Comments

Linx Technologies announced a new series of RF modules designated the ES. The ES series combines the cost and size benefits of the LC family, the range, noise immunity and performance of the HP series, and the legal attractiveness of future multi-band availability. Housed in a SMD package, the ES series offers a combination of features, performance and cost-effectiveness....

Bluetooth RF Module

February 27, 2002 9:34 am | Wireless Design & Development | Product Releases | Comments

Taiyo Yuden introduced a small RF module for the next generation of Bluetooth-based wireless communications devices, including cell phones and PDAs. The ultra-compact RF module employs a unique LTCC (Low Temperature Co-fired Ceramics) substrate that is achieved by embedding the filter, inductors and capacitor into the substrate and using flip-chip assembly techniques to mount the semiconductor....

VCO for Digital Microwave Radio

February 27, 2002 9:34 am | Product Releases | Comments

Z-Communications introduced the V910ME02 for demanding digital microwave radio applications. The V910ME02 is guaranteed to generate frequencies between 4245 and 4335 MHz within 0.5 to 8 V DC of control. At this frequency range, this VCO provides a pure spectral signal of – 87 dBc/Hz, typically, at 10 kHz from the carrier while attenuating the second harmonic to better than – 13 dBc....

Advertisement

Voltage Regulators With Low Ground Current

February 27, 2002 9:34 am | Product Releases | Comments

Two new 150 mA low-noise low dropout (LDO) regulators designed for use in battery-powered equipment such as cell phones, wireless handsets and modems, PDAs, notebooks, pagers and digital cameras were announced by Siliconix incorporated, a subsidiary of Vishay Intertechnology. The Si91841 and Si91843 feature a low ground current of 110 μA at 150 mA — ideal for low-voltage battery-operated power systems — and a low dropout volta...

Turnable Coaxial Connector

February 25, 2002 4:20 am | Product Releases | Comments

Rosenberger introduces a 360°-turnable, right-angle coaxial connector that is custom-made for automotive applications with small spaces or limited accessibility. The unique turnable connector is resistance to a wide temperature range (-40°C up to +100°C) and features ultra-small dimensions (minimum pitch 10 mm, housing incl....

Compliant Transition Guides

February 25, 2002 4:20 am | Product Releases | Comments

Bivar introduces the cPCI-T Series™ Transition Guides designed specifically for compact PCI (cPCI™) applications. The cPCI-T Transition Guides are the latest in Bivar's new family of CPCI components and accessories being introduced to this market. Offering OEMs increased packaging flexibility, the new guides meet all requirements for a wide variety of cPCI applications including those for the electronic enclosure, single board compu...

Power Cross Portection Fuse

February 25, 2002 4:20 am | Product Releases | Comments

Now available from Bel is the SMP surface mount, power cross protection fuse. Developed to ensure compliance with the Power Cross test requirements UL 1950/60950 and Bellcore/Telcordia GR-1089 for Tip and Ring protection, the device further withstands lightning surges specified in FCC 47 Part 68....

SMT LED Lamps

February 25, 2002 4:20 am | Product Releases | Comments

Continuing to innovate on its offerings of direct incandescent replacement LED (light emitting diode) lamps for process-control and machine status-indicator towers, LEDtronics announced the availability of StackLED® SMT LED lamps. These lamps are manufactured using SMT (surface mount technology) processes and incorporate 1206-profile SMT LEDs, resulting in StackLED lamps with unprecedented brightness and reliability....

Lamp Driver

February 25, 2002 4:20 am | Product Releases | Comments

Durel Corporation announces the immediate availability of its new high performance D381A electroluminescent (EL) lamp driver for PDAs and other wireless electronic devices. This new IC inverter offers designers the ultimate design flexibility with the lowest audible noise. With the D381A EL driver, designers can achieve longer EL lamp and battery life while delivering much higher EL lamp brightness for large area liquid crystal displays (LC...

Point-to-Point Wireless Kits

February 25, 2002 4:20 am | Product Releases | Comments

Agere Systems announced the availability of the ORiNOCO™ Point-to-Point Radio Backbone Kit that makes it easier and more affordable to connect to buildings up to six miles apart with a high-speed (11 Mbps) point-to-point wireless network. By using the Point-to-Point Radio Backbone Kit, businesses no longer have to invest in expensive leased or T1 lines, or set up microwave towers, to provide secure, high-speed connectivity between locat...

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading