Advertisement
The Source on Design and Technology for the Wireless and RF Engineer
Subscribe to Wireless Design and Development All
View Sample

FREE WDD Email Newsletter

Packaging System

November 7, 2003 6:14 am | Product Releases | Comments

GPAX announces TekPAX, a tape and reel packaging and feeding system that handles mechanical components. The tape and reel packaging system protects components by placing each one in a custom-designed GPAX tape carrier. Because the components are packaged separately, they do not interact with each other....

Crystals and Oscillators

November 7, 2003 6:14 am | Wireless Design & Development | Product Releases | Comments

A variety of Crystek crystals and oscillators at a frequency of 49.152 MHz meet the specifications of the TSB41BA3. the crystal is a fundamental 49.152 MHz 5 × 7 mm SMD, and the oscillator is 49.152, 1.8 V, 5 × 7 mm SMD. The products are specified for 0°C/+70°C, – 40°C/+85°C and – 55°C/+125°C operating temperature....

Modules

November 7, 2003 6:14 am | Product Releases | Comments

FlexiPanel modules provide connection to a range of remote devices including Pocket PCs and Palm Pilots. The sotware on the remote devices does not need to be customized to suit each product....

Advertisement

Self-Calibrating Transmitter

November 7, 2003 6:14 am | Product Releases | Comments

BlueLynx Model BLM-TX is a wireless sensor link designed to replace cable and conduit in data acquisition applications. This unit collects analog signals from up to four 4 to 20 mA sensors, then transmits the signals to a BlueLynx Model BLM-RX receiver, a Bluetooth access point or a Bluetooth PC serial port adapter....

DC Current Transducers

November 7, 2003 6:14 am | Product Releases | Comments

American Aerospace Controls (AAC) introduces a series of DC current transducers that provide tight accuracy to 1.0% FS for stable operation over a temperature range of – 40°C to 85°C. Series 920 and 921 transducers automatically monitor system data remotely. Each sensor uses a two-wire connection....

IMD/Diplexer

November 7, 2003 6:07 am | Product Releases | Comments

By James Penny, Filtek Corporation This article is intended to acquaint and provide system users and subsystem designers insight to the importance of IMD (Intermodulation Distortion) suppression in bi-directional amplifier systems. Many types of bi-directional amplifiers are in abundant use in cellular systems....

E911 GPS Mandate Challenges Accepted Antenna Designs

November 6, 2003 10:25 am | Product Releases | Comments

By Andrew Beutmueller In June of 1996, the Federal Communications Commission (FCC) proposed the Enhanced 911 (E911) Mandate # 94-102. During phase I of the FCC order, carriers were required to provide 911 operators with the caller's telephone number as well as the base station location. Clearly this was not precise enough for mortal emergencies....

Wafer Probe System

November 3, 2003 6:54 am | Product Releases | Comments

Cascade Microtech announces a series of 200 mm semiautomatic and manual Summit Probe Stations. The Summit B series is an upgrade to Cascade's Summit 11000 and 12000 series. All Summit B stations are designed to be upgraded in the field. All Summit B series also incorporate high-force probing as standard, accommodating probe card loads up to 20 kg (45 lbs)....

Advertisement

Field Configurable Gauge

November 3, 2003 6:54 am | Product Releases | Comments

Eurotherm, Action Instruments group announces the WV Series model WV448, bridge or strain gauge input, isolating signal conditioner with TouchCAL™ technology. This high density, field configurable, DIN rail mount device accepts bridge/strain gauge input and provides a proportional, selectable DC output....

Programmable SoC

November 3, 2003 6:54 am | Product Releases | Comments

Cypress MicroSystems announces programmable System-on-Chip (PSoC) devices for portable, flash-based applications, including remote sensors, handheld instruments, and portable consumer electronics. PSoC devices are high-performance, field-programmable, mixed-signal arrays for high-volume embedded-control functions....

Multilayer Varistors

November 3, 2003 6:54 am | Product Releases | Comments

Vishay announces a range of multilayer varistors that combine typical 0.5 ns response time with capacitance values down to 70 pF (25 pF optional) in accordance with CECC42000 and IEC 61051-1. Devices in the MLV 2322 573 (0603 case size) and 2322 574 (0805 case size) series are suited for protecting sensitive components from incoming overvoltage transients....

Electronic Hardware

November 3, 2003 6:54 am | Product Releases | Comments

A selection of electronic hardware manufactured to U.S. National Aerospace Standards (NAS) is available from RAF Electronic Hardware. Electronic hardware manufactured to NAS specifications includes standoffs, spacers, swage spacers, and male/female standoffs. The NAS components compliment a similar line of special handles from RAF designed to meet U....

Laser Diode Module

November 3, 2003 6:54 am | Product Releases | Comments

California Eastern Labs announces an uncooled, 1310 nm, directly-modulated laser diode module from NEC. Designed for 10G transmission applications, NEC's NX8340 Series modules are 10G AlGaInAs uncoolded DFB laser diodes fabricated using Al oxidation-free all-selective MOVPE without semiconductor etching....

Drive Test Equipment

November 3, 2003 6:54 am | Product Releases | Comments

ZK Celltest has added PN Scanning as an optional feature on its DXM line of test equipment. PN scanning detects and logs all desirable and undesirable (interfering) PN signals impacting working subscriber phones in a CDMA network. Undesirable PN signals at levels close to the Active Sets result in Pilot Pollution that is interference, which causes poor audio quality and high FER....

Microwave Ceramics

November 3, 2003 6:54 am | Wireless Design & Development | Product Releases | Comments

Temex introduces a range of microwave ceramics dedicated to space applications. The E3000 range is designed to make complete oscillator assemblies stable throughout the environments experienced in space. The E3000 family is targeted at space and military applications requiring temperatures ranging from – 55°C to +125°C....

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading