Advertisement
The Source on Design and Technology for the Wireless and RF Engineer
Subscribe to Wireless Design and Development All
View Sample

FREE WDD Email Newsletter

Analyzer Cards

January 21, 2004 10:48 am | Product Releases | Comments

Acqiris introduces Model AP240 and AP235 dual-channel reconfigurable analyzer platforms with Sustained Sequential Recording (SSR) firmware capability. The SSR firmware enhances the analyzers' ability to acquire, store and transfer sequential waveforms to a host PC at sustained trigger rates. The firmware options uses FPGA technology and enables the AP240/235 platforms' Data Processing Unit (DPU) to store the digitized waveforms in a "pi...

Radio and I/O Module

January 21, 2004 10:48 am | Product Releases | Comments

Phoenix Contact introduces the MCR-RAD, an integrated radio and I/O module designed to eliminate cable and conduit for analog and digital signals in harsh industrial environments. This module uses spread spectrum frequency hopping techniques to guarantee a license-free, interference-free link between remote devices and the control room....

Transceivers

January 21, 2004 10:48 am | Product Releases | Comments

AeroComm introduces the AC4490-1x1. the modules contain AeroComm's RF232 embedded protocol, which allows for plug-and-play installation. The 1x1's TTL serial interface provides bi-directional communication in point-to-point, point-to-multipoint, or multi-to-multi networks. Key specifications include: up to 115....

Advertisement

Common Mode Choke

January 21, 2004 10:48 am | Product Releases | Comments

API Delevan announces the CM6149 common mode-choke series, featuring an epoxy potted surface mount configuration. The potting shell is a molded, thermo-set epoxy material with molded in terminals that provide coplanarity. The core is a high permeability ferrite toroid. Series CM6149 is available in 13 inductance values ranging from 25 μH to 2,200 μH....

Coaxial Resonator Oscillators

January 21, 2004 10:48 am | Product Releases | Comments

Atlantic Microwave introduces coaxial resonator oscillators in the ACR series. The Series provides a stabilized fixed output frequency in the range 300 MHz to 3000 MHz with a minimum of +13 dBm of output power. Stability is achieved using a high Q ceramic resonator in a low noise silicon FET circuit with the output buffered to minimize frequency pulling....

Epoxy System

January 21, 2004 10:48 am | Wireless Design & Development | Product Releases | Comments

Tra-Bond 2254 is recommended for high temperature aerospace and electronics applications. Tra-Bond 2254 is a two-part thixotropic epoxy system that is color coded for easy handling and mixing at room temperature. This adhesive requires a heat cure, and bonds to ceramics, glass, metals and plastics....

Thin Sheets

January 21, 2004 10:48 am | Product Releases | Comments

Clarex precision thin sheets are manufactured using a specialized cell-casting method. Available in a range of thicknesses from 0.008 to 0.197 inches, the Clarex sheets are available with a hard coating on either one or both sides to prevent surface scratching....

Gunn VCO

January 21, 2004 10:48 am | Product Releases | Comments

Spacek Labs Model GU-529P is a high-power Gunn transmitter source. Output power is 125 mW (minimum). Varactor tuning is ± 100 MHz (minimum) at a modulation rate of up to 50 MHz. The varactor bias is 0 to +15 volts. The Gunn bias is +9 volts @ 0.3 amps. The Gunn is available at any frequency between 50 and 60 GHz as the center frequency....

Advertisement

Power Conversion ICs

January 21, 2004 10:48 am | Product Releases | Comments

Power Integrations announces the Design Accelerator Kit (DAK-32). The DAK-32 features a 20 W power supply reference design that meets a one-watt standby input power consumption. The DAK-32 contains a 20 W universal input AC/DC power supply, PI Expert design software, TOPSwitch-GX power conversion IC samples, and design collateral....

Block Down Converter

January 21, 2004 10:48 am | Product Releases | Comments

Tampa Microwave announces the LNB-6300-50-112 low noise block down converter. This X band LNB converts the X band downlink frequencies of 7.25 to 7.75 to an output frequency of 950 to 1450 MHz. Key performance specifications include conversion gain of 50 dB, typical noise figure of 1.3 dB typical and flatness of ± ....

Front End Receiver

January 21, 2004 10:48 am | Product Releases | Comments

RF Micro Devices announces the RF2861 single-band receiver front end with an integrated TX LO buffer amplifier designed for CDMA cellular, JCDMA and CDMA450 applications. The RF2861 features a 3 × 3 mm footprint. The RF2861 allows handset engineers to achieve design goals and accelerate time-to-market....

Pull Test Instrument

January 21, 2004 10:48 am | Product Releases | Comments

MiTel introduces their portable tensile strength pull tester used to certify the quality of crimp-on solderless lug, ring, funnel barrel, tongue and spade terminals to wire. The MPT-500 instrument is a portable tool using a handheld ratchet-action tester to make destructive pull type force measurements to crimp-on terminals terminated to wire, exerting up to 200 pounds of force....

DC Power Supply

January 21, 2004 10:48 am | Product Releases | Comments

Model P6000 programmable DC power supply features an RS 232/485 interface for PC or front panel keyboard program entry. With ± 36 V at 3 A output, this source will store 10 voltage current settings in memory. Program setting time is 10 mS for voltage increase and 10 mS for decreasing voltage....

LED Lamps

January 21, 2004 10:48 am | Product Releases | Comments

BivarOpto introduces an all-in-one LED-based lighting alternative for incandescent spot and flood lamps. The INFINITE 1 series design includes an Edison based housing assembly directly interchangeable with PAR style spots and floods. Thirty-nine Super-Flux MAKO LEDs are arranged in a grid-array pattern to project an evenly distributed light pattern....

Hardware

January 21, 2004 10:48 am | Product Releases | Comments

Micro Plastics introduces the Snap Latch. The Snap Latch pin and body are supplied as two separate parts. Both sections are modled in a UL94-V2 natural Nylon 6/6 material....

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading