Advertisement
The Source on Design and Technology for the Wireless and RF Engineer
Subscribe to Wireless Design and Development All
View Sample

FREE WDD Email Newsletter

ADCs

February 25, 2003 12:07 pm | Product Releases | Comments

The LTC2412 is a 24-bit No Latency Delta Sigma™ ADC that offers two fully differential input channels and a differential reference input. Low noise of 800 nVRMS provides 22.5 effective number of bits (ENOBs) over a ± 2.5 V span and 16.9 ENOBs over a ± 50 mV span. Operating from a single 2....

Analog Comparator/Interrupter

February 25, 2003 12:07 pm | Product Releases | Comments

The VM4018 can accurately detect and respond to level changes over a wide range of voltages. A precision DAC provides the reference voltage for each comparator channel. Input ranges can be individually selected form ± 1 V to ± 250 V. the flexible interrupt feature can be configured to initiate other events autonomously through the TTL trigger lines, or interrupt the processor....

LED Driver IC

February 25, 2003 12:07 pm | Product Releases | Comments

Fairchild's family of tightly matched, binned LEDs, in conjunction with complementary LED driver ICs, provide a range of matching and brightness control in cellular phones, PDAs, and other portable applications. These LEDs run directly from the battery, with no boost required. The QTLP6XX series of low V F surface mount LEDs feature low voltage operation for low power consumption and a narrow forward voltage range....

Advertisement

Microprocessor

February 25, 2003 12:07 pm | Product Releases | Comments

The Rabbit 3000® microprocessor comes in a small form factor TFBGA (Thin Fine Pitch Ball Grid Array) package. The device has a footprint of 10 × 10 mm, with a 1.2 mm thickness and a 0.8 mm pitch. The Rabbit 3000 runs at up to 54 MHz and is C-friendly, with compact code and direct software support for 1 MB of code/data space....

CDMA Transmitter

February 25, 2003 12:07 pm | Product Releases | Comments

Crocodile™ CDMA Transmitter now features an optional internal CW module allowing Crocodile to transmit a continuous wave signal from 25 to 45 watts (cellular) or 10 to 20 watts (PCS) depending upon the configuration. Both CDMA and CW are housed together in the same portable, ruggedized case weighing 24 pounds....

Power Connectors

February 25, 2003 12:07 pm | Product Releases | Comments

American Conec introduces its filtered combo D-SUB power connectors with integrated die cast back shell. Filter capacitors are fully integrated into the connector with capacitance ranges of 1.3 nF up to 100 nF. This filtered power connector has a standard dielectric withstanding voltage of 707 V DC, with a high voltage version of 1020 V DC available....

Transformer Tester

February 25, 2003 12:07 pm | Product Releases | Comments

The PF-401 is a bench top test system for transformers up to 10 KVA. It is a go/no-go system for production testing or incoming inspection. LED display shows primary test voltage, no load current, core losses and up to five open secondary voltages. The display indicates No-pass status with or without audible alarm....

Software for Analyzers

February 25, 2003 12:07 pm | Product Releases | Comments

Agilent introduces a software application for its spectrum analyzer families, which allows multichannel power amplifier (MCPA) designers to achieve the lowest possible distortion and highest linearity with the least amount of effort and complexity. The 8960A distortion test suite can be used with Agilent ESA-E or PSA Series spectrum analyzers or 89600 Series vector signal analyzers....

Advertisement

Radio Measurement Platform

February 25, 2003 12:07 pm | Product Releases | Comments

Anite introduces the U-RAMS UMTS radio measurement platform. The U-RAMS enables the ability of the user to perform RF conformance tests, as specified by the 3GPP, on their handsets. The U-RAMS incorporates automated conformance test scripts, as well as a comprehensive set of logging, error recovery and analysis tools that minimize test time and streamline the development and introduction of user equipment devices....

Regulator IC

February 25, 2003 12:07 pm | Product Releases | Comments

The Si9185 is a 500 mA CMOS low dropout (LDO) regulator that features low dropout and ground current in a compact, thermally enhanced MLP33 PowerPAK package. With low dropout of 150 mV at 500 mA, and a 3 × 3 mm footprint, the Si9185 is designed to prolong battery life in compact, portable electronics....

Analog Switch

February 25, 2003 12:07 pm | Product Releases | Comments

The FSA3357 device is a single pole/triple throw (SP3T) CMOS analog switch. The switch features an R DS(on) of 6 Ohms resulting in minimal signal attenuation. The devices 0.01% total harmonic distortion (THD), coupled with its – 60 dB crosstalk characteristic, ensures signal integrity. A wide V CC range of 1....

Dual Rate VCXOs

February 25, 2003 12:07 pm | Product Releases | Comments

The 7311J series has a 155.52 MHz/FEC rate (selectable) with a single CMOS output signal. The 7311K series has a 622.08 MHz/FEC rate selectable) with a single ended sine wave output signal. The 7311Q series has a 622.08 MHz/FEC rate (selectable with a LVPECL complementary output signal. The 7311T series has a 155....

Thermistors

February 25, 2003 12:07 pm | Product Releases | Comments

The NT73 negative tempco thermistors are mechanically strong and feature a low profile. The thermistors feature anti-leaching nickel barrier terminations (90/10 solder plated, standard) and twelve standard resistance values from 1.0 kΩ through 150 kΩ. Sizes 0603, 0805, and 1206 are available....

Switched Filter Bank

February 25, 2003 12:07 pm | Product Releases | Comments

MITEQ offers a wideband integrated switchable LNA filter assembly that allows the user to switch between several overlapping frequency ranges. This system combines low loss, high rejection bandpass filters with low noise amplifiers that provide for superior RF performance and reliability. The devices exhibit excellent isolation between frequency bands by utilizing MITEQ's PIN switch technology....

Miniature Transformers

February 25, 2003 12:07 pm | Product Releases | Comments

The 786 series transformers are available in surface mount and through-hole versions and are ideal for applications such as line coupling, matching, and isolation. Inductance values are to 10 mH and isolation ratings of 1 kVrms. The transformers offer primary inductance values of between 100 μH and 10 mH and all employ a toroidal construction....

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading